# Set/Display parameters vertically
**URL:** https://www.finalbuilder.com/forums/t/set-display-parameters-vertically/3801
**Category:** Feature Requests
**Created:** [December 23, 2006, 11:57am UTC](https://www.finalbuilder.com/forums/t/set-display-parameters-vertically/3801 "2006-12-23T11:57:19Z")
**Posts on this page:** 3
**Page:** 1
### Author:  [@wasowerby](https://www.finalbuilder.com/forums/u/wasowerby)
#### Post date: [December 23, 2006, 11:57am UTC](https://www.finalbuilder.com/forums/t/set-display-parameters-vertically/3801/1 "2006-12-23T11:57:19Z")
It would be very helpful to allow entering and display of parameters per line vertically. For example, I have 8+ long parameters to enter in an Execute Program’s Parameters box. It is a pain to have to enter all these parameters on a single, limited length, edit box!
---
### Author:  [@raoul](https://www.finalbuilder.com/forums/u/raoul)
#### Post date: [December 27, 2006, 8:30am UTC](https://www.finalbuilder.com/forums/t/set-display-parameters-vertically/3801/2 "2006-12-27T08:30:56Z")
Andrew,
if you hit F2 on the single line you get a dialog which should make it easier to enter this command line.
Cheers
---
### Author:  [@wasowerby](https://www.finalbuilder.com/forums/u/wasowerby)
#### Post date: [December 28, 2006, 2:56am UTC](https://www.finalbuilder.com/forums/t/set-display-parameters-vertically/3801/3 "2006-12-28T02:56:03Z")
Thanks Raoul, didn’t spot that. Just what I was looking for.Regards…Andrew